Cabling for USB & DB9 monitoring and EPO switching
PowerAlert unattended shutdown and UPS/Power monitoring
software
Warranty information and instruction manual
SMART500RT1U UPS System
Mounting hardware
Cabling for USB & DB9 monitoring and EPO switching
PowerAlert unattended shutdown and UPS/Power monitoring
software
Warranty information and instruction manual
Software Included: PowerAlert Software
Additional Information:
SMART500RT1U line interactive UPS offers battery derived sine
wave AC output during power outages, voltage regulation during
brownouts, plus network-grade AC surge suppression
500VA / 300 watt power handling capability compatibile with
networking, telecom and other sensitive electronic devices
Supports 1U rackmount installation in 2 or 4 post rack
enclosures, upright tower placement also supported - mounting
accessories included
Large internal batteries offer runtimes of 17 minutes at half
load (250VA / 150 watts) and 5 minutes at full load (500VA / 300
watts)
Maintains regulated 120V nominal output during brownouts as low
as 90V
Includes 6 UPS-supported outlets, with one single outlet load
bank that can be powered off and back on again via software
interface. One additional surge-only outlet powers accessories not
requiring battery support
PowerAlert UPS monitoring and unattended shutdown software
enables configurable network broadcast messaging, pager &
email notification, event logging and running user-defined script
commands
Offers simultaneous monitoring by up to 3 directly-connected
devices through included USB, DB9 and SNMP* interfaces (*requires
optional SNMPWEBCARD), or the monitoring of any number of
additional UPS systems over IP with included PowerAlert monitoring
software. Free PowerAlert enterprise management software is also
available for select opportunities
Communications ports support messaging of UPS and line power
status, including on-battery, low-battery, power restored, AC line
voltage, DC battery voltage and remaining battery capacity
Supports timed inverter shutoff after unattended shutdown,
activate self-test and UPS output power control for scheduled or
immediate reboot of connected devices
Supports Tripp Lite's WatchDog software application to restore
unresponsive programs by systematically restarting applications,
operating systems and ultimately rebooting completely locked
computers by momentarily switching UPS power off and back on again
(requires optional WATCHDOGSW)
Built-in accessory slot supports SNMP with optional SNMPWEBCARD
adapter
Emergency Power Off (EPO) interface with cable
Multi-function audible alarms and set of 5 front panel
LEDs
Network-grade AC surge suppression
Attractive all-black color scheme
UPS battery set ships fully assembled and ready for
installation, no time consuming connection of internal batteries by
user is necessary
Two year warranty with $250,000 connected equipment insurance
(USA & Canada only)
Battery Information
Maximum Battery Recharge Time: 4 Hour
Backup/Run Time (Half Load): 17 Minute
Backup/Run Time (Full Load): 5 Minute
Battery Life: 6 Year
Battery Chemistry: Sealed Lead Acid
Hot Swappable: Yes
Power Description
Load Capacity (VA): 500 VA
Load Capacity (Watt): 300 W
Input Voltage: 110 V AC
Output Voltage: 120 V AC
Surge Energy Rating: 480 J
Waveform Type: Pulse-width Modulated Sine
Wave
Management
Network Management: SNMP Manageable
Alarm:
On Battery
Overload
UPS Fault
Low Battery
Warranty
Limited Warranty: 2 Year
Controls/Indicators
Status Indicators: 5 front panel LEDs - Green
POWER LED, 3 color BATTERY CHARGE LED, 3 color OUTPUT LOAD LEVEL
LED, red BATTERY WARNING LED.