Altronix Power Device

Altronix NetWay4EWP 4-Port PoE+ Hardened Switch - Network (RJ-45) - 4x PoE+ (RJ-45) Ports - Gigabit Ethernet - 10/100/1000Base-T, 1000Base-X - 1 x Expansion Slots - SFP - 1 x SFP Slots - External

Altronix Voltage Regulator. 24VDC Input into 5VDC or 12VDC Output

Altronix Access and Power Integration Kit

Altronix Access and Power Integration

Altronix eBridge1ST EoC and PoE/PoE+ Transceiver - 1 x Network (RJ-45) - 1x PoE (RJ-45) Ports - Fast Ethernet - 10/100Base-TX

Altronix IP and PoE+ Over Extended Distance CAT5e - mini Transceiver

Altronix AL175ULB Proprietary Power Supply - Wall Mount - 24 V AC Input - 1 +12V Rails

Model 6062 programmable timer is suitable for many functions that require a timed operation e.g. Access Control Applications, Siren/Bell Cut Off Module, Dialer Delay, Guard Tour Supervisory Timer, etc. Some optional functions include: One Shot, Delayed Release, Delayed Operate, Delayed Pulse and Pulser/Flasher. A new feature has been added which provides a momentary relay activation at the end of a desired timing cycle. This feature eliminates the need for having to use two (2) timers to achieve this function. Another new feature will cancel (interrupt) timing cycle and reset timer if desired.

ACM8E unit converts one (1) 12 to 24 volt AC or DC input into eight (8) independently controlled fuse protected outputs. These power outputs can be converted to dry form C contacts. Outputs are activated by an open collector sink or normally open (NO) dry trigger input from an Access Control System, Card Reader, Keypad, Push Button, PIR, etc. The unit will route power to a variety of access control hardware devices including Mag Locks, Electric Strikes, Magnetic Door Holders, etc. Outputs will operate in both Fail-Safe and/or Fail-Secure modes. The unit is designed to be powered by one common power source which will provide power for both the board operation and locking devices, or two (2) totally independent power sources, one (1) providing power for board operation and the other for lock / accessory power. The FACP Interface enables Emergency Egress, Alarm Monitoring, or may be used to trigger other auxiliary devices. The fire alarm disconnect feature is individually selectable for any or all of the eight (8) outputs.